Detailed Product Description

Submersible Pump Motor (6SD)

Meet the requirements of Standard IEC34-1 with fully sealed shaft 6 inches NEMA standard flange connector Angular contact bearing installed on the bottom side of motor standing for even more axial loadWith stainless steel shaft, credible mechanical sealsAxial load:15,500NWith throw sand bush, reinforced butyl rubber house for press balance device 
Specofocation

Power:three phase,4kw~18.5kw
Power supply: three phase, 400V±10%,50HZ ,direct start
Protection class:IP68
Insulation class:F
Water temperature: up to 35
PH:6.5-8.0
Minimum water flux through motor:16cm3/s
Maximum numbers of start:20/h
Vertical or horizontal installation
Anti water connect cable: 3x4.0mm2 or 3x6.0mm2
 

To find more detail about the submersible pump, please browse our website

Our water pumps includes 4SD deep well pump, MXS submersible pump, KBZ submersible dewatering pump, KBS submersible slurry pump, WQ sewage pump, JET Self -Priming Jet Pump, CPM Micro Centrifugal Pump, borehole pump, QB60 Micro Vortex Pump, shredder pump, QXN submersible pump, QDX submersible pump.Drainage Pumps